Allied-telesis AT-GS950/16 User Manual download pdf (Page 316)

Chapter 23: LLDP

316

Enabling or

Disabling LLDP

To enable or disable the LLDP feature, perform the following procedure:

1. From the main menu on the left side of the page, click the LLDP folder.

The LLDP folder expands.

2. From the LLDP folder, select LLDP Global Settings.

3. For the LLDP parameter, select one of the following radio button

choices:

Enabled: The LLDP feature is active.

Disabled: The LLDP feature is inactive.

Note

The LLDP feature is not dependent on the DHCP feature. As a

result, the DHCP feature can be set to either Enabled or Disabled

without affecting LLDP.

4. Click the Apply button to the right of the either the Enabled or

Disabled radio buttons.

The LLDP setting that you have selected is now active.

5. Below the Enable or Disable radio buttons, you may adjust the

following parameters as needed, then click the Apply button in the

area of these parameters:

Message TX Hold Multiplier: Sets the hold multiplier value. The

hold time multiplier is multiplied by the transmit interval to give the

Time To Live (TTL) that the switch advertises to the neighbors.

The range is from 2 to 10.

Message TX Interval: Sets the transmit interval, which is the

interval between regular transmissions of LLDP advertisements.

The range is from 1 to 10 seconds.

LLDP Reinit Delay: Sets the reinitialization delay, which is the

number of seconds that must elapse after LLDP is disabled on a

port before it can be reinitialized. The range is from 1 to 10

seconds.

LLDP TX Delay: Sets the value of the transmission delay timer,

which is the minimum time interval between transmissions of LLDP

advertisements due to a change in LLDP local information. The

range is from 1 to 8192 seconds.

6. From the main menu on the left side of the page, select Save Settings

to Flash to permanently save your changes.

1 2 ... 311 312 313 314 315 316 317 318 319 320 321 ... 403 404

No comments

Allied-telesis AT-GS950/16 User Manual Page 316