Dynamic Host Configuration Protocol DHCP Relay Command Reference
iMG/RG Software Reference Manual (System Administration)
5-80
5.1.7.1 DHCP relay CLI commands
The table below lists the DHCP relay commands provided by the CLI:
TABLE 5-3 DHCP Relay Commands
5.1.7.1.1 DHCPRELAY ADD SERVER
Syntax DHCPRELAY ADD SERVER <IPADDRESS>
Description This command adds the IP address of a DHCP server to the DHCP relay's list of server
IP addresses. The relay can store a maximum of 10 DHCP server addresses. Any new
server IP addresses added are not actually used until the DHCPRELAY UPDATE com-
mand has been entered.
Options The following table gives the range of values for each option which can be specified with
this command and a default value (if applicable).
Example --> dhcprelay add server 239.252.197.0
See also dhcpserver list subnets
dhcprelay update
Commands
Fiber
A
Fiber
B
Fiber
C
Fiber
D
Fiber
E
Modular
ADSL
A
ADSL
B
ADSL
C
DHCPRELAY ADD SERVER XXXXX X X X X
DHCPRELAY CLEAR SERVERS XXXXX X X X X
DHCPRELAY DELETE SERVER XXXXX X X X X
DHCPRELAY ENABLE|DISABLE XXXXX X X X X
DHCPRELAY LIST SERVERS XXXXX X X X X
DHCPRELAY SHOW XXXXX X X X X
DHCPRELAY UPDATE XXXXX X X X X
Option Description Default Value
ipaddress The IP address of a DHCP server that DHCP relay
can use. The IP address is displayed in the IPv4 format
(e.g 192.168.102.3)
N/A
Comments to this Manuals