Allied Telesis AT-8900 SERIES Installation Guide

AT-8900 SERIES QUICK INSTALL GUIDE

Configuring the SwitchSome configuration is necessary to enable the switch’s advanced switching capabilities. This is achieved via the Command Line In

Quick Install Guide 11C613-04048-01 REV BAlternatively, type a question mark (?) at the end of a partially completed command to see a list of valid op

12 AT-8900 SeriesC613-04048-01 REV BPSU and FOM LEDsThe AT-8900 Series Hardware Reference has further troubleshooting information, including informati

AT-8900 Series Quick Install GuideDocument Number C613-04048-01 REV B.Copyright © 2004 Allied Telesyn International, Corp.19800 North Creek Parkway, S

Quick Install Guide 3C613-04048-01 REV BModels Covered By This GuideThis Quick Install Guide includes information on the following models: AT-8948Qui

4 AT-8900 SeriesC613-04048-01 REV BSelecting a SiteThe switch can be installed in a standard 19 inch rack, on a level surface such as a desktop or ben

Quick Install Guide 5C613-04048-01 REV BInstalling the SwitchThis equipment must be earthed.Follow these steps to install the switch:1. Read the safet

6 AT-8900 SeriesC613-04048-01 REV BFigure 1: Fitting rack-mount brackets on the switchFront BracketBracketRear bracketAAARear BracketABAdjustable brac

Quick Install Guide 7C613-04048-01 REV BTo install the switch using the wall-mount kit:• Ensure that there is sufficient space on the wall for the swi

8 AT-8900 SeriesC613-04048-01 REV BThe wall-mount kit is purchased separately. To order a wall-mount kit, contact your authorised Allied Telesyn distr

Quick Install Guide 9C613-04048-01 REV B3. Connect the ground wire to the ground terminal. Terminals can be identified by the diagram on the switch’s