Allied Telesis Summit 24 User's Guide download pdf (Page 157)

Relative Route Priorities

Summit 300-48 Switch Software User Guide 157

Relative Route Priorities

Table 55 lists the relative priorities assigned to routes depending upon the learned source of the route.

CAUTION

Although these priorities can be changed, do not attempt any manipulation unless you are expertly

familiar with the possible consequences.

To change the relative route priority, use the following command:

config iproute priority [ bootp | icmp | static ] <priority>

Configuring IP Unicast Routing

This section describes the commands associated with configuring IP unicast routing on the switch. To

configure routing, follow these steps:

1 Create and configure two or more VLANs.

2 Assign each VLAN that will be using routing an IP address using the following command:

config vlan <name> ipaddress <ipaddress> {<mask>}

Ensure that each VLAN has a unique IP address.

3 Configure a default route using the following command:

config iproute add default <gateway> {<metric>}

Default routes are used when the router has no other dynamic or static route to the requested

destination.

4 Turn on IP routing for one or all VLANs using the following command:

enable ipforwarding {vlan <name>}

Table 55: Relative Route Priorities

Route Origin Priority

Direct 10

BlackHole 50

Static 1100

ICMP 1200

BOOTP 5000

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 197 198

No comments

Allied Telesis Summit 24 User's Guide Page 157