Allied Telesis Switch AT-SBXPWRSYS1 User Manual download pdf (Page 154)

Chapter 7: Powering On the Chassis

154

Verifying the Installation

Please perform the following procedure before powering on the chassis:

1. Verify that the grounding lug on the back panel of the chassis is

properly grounded. For instructions, refer to “Installing the Chassis

Grounding Lug” on page 90.

2. Verify that all empty slots on the front panel of the chassis are covered

with slot covers. To cover open slots, perform the procedure “Installing

the Blank Slot Covers” on page 124.

3. Verify that dust plugs are installed in all empty SFP, SFP+, CSFP, and

XFP slots on the Ethernet line cards.

4. Verify that dust covers are installed on all SFP, SFP+, CSFP, and XFP

transceivers that do not have cables.

5. Verify that the chassis has at least one AT-SBx31CFC Control Card

installed in slot 4 or 5.

6. Verify that the chassis has at least one AT-SBxPWRSYS1 Power

Supply in slot C or D.

7. If the chassis has AT-SBx31GP24 Line Cards, verify that the chassis

has at least one AT-SBxPWRPOE1 Power Supply in slot A or B.

8. When you installed the AT-SBx31CFC Control Card, did you remove

the battery insulator, shown in Figure 72 on page 116? If not, remove

the control card from the chassis, remove the insulator from the

battery, and reinstall the card.

You may now power on the chassis. For instructions, refer to the

appropriate procedure:

 “Powering On the AT-SBxPWRSYS1 AC Power Supply” on page 155

 “Powering on the AT-SBxPWRPOE1 AC Power Supply” on page 158

 “Powering On the AT-SBxPWRSYS1 DC System Power Supply” on

page 161

Note

If the chassis has both AT-SBxPWRSYS1 and AT-SBxPWRPOE1

Power Supplies, you may power on the power supplies in any order.

The power supplies may also be powered on simultaneously.

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 221 222

No comments

Allied Telesis Switch AT-SBXPWRSYS1 User Manual Page 154