Allied Telesis Switch AT-SBXPWRSYS1 User Manual download pdf (Page 192)

Chapter 8: Verifying the Hardware Operations of the Chassis

192

Using Local Management to Verify the Chassis

This section explains how to confirm the operations of the chassis with the

commands in the management software on the control card. The section

has the following procedure:

 “Starting a Local Management Session” on page 192

 “Entering the Management Software Commands” on page 193

The initial management session must be a local management session. For

instructions on how to configure the chassis for remote management with

Telnet and Secure Shell clients, refer to Software Reference for

SwitchBlade x3100 Series Switches.

Starting a Local

Management

Session

To start a local management session, perform the following procedure:

1. Connect the RJ-45 end of the management card included with the AT-

SBx31CFC Controller Fabric Card to the Console RS-232 port on the

front panel of the AT-SBx31CFC Card, as shown in Figure 144. If the

chassis has two control cards, you must connect the cable to the

Console RS-232 port on the active card. To determine which card is

the active card, examine the M/S LEDs. The LEDs are green on the

active card and amber on the standby card.

Figure 144. Connecting the Management Cable to the Console RS-232

Port

1 2 ... 187 188 189 190 191 192 193 194 195 196 197 ... 221 222

No comments

Allied Telesis Switch AT-SBXPWRSYS1 User Manual Page 192