Allied-telesis AT-8550SP User Manual download pdf (Page 53)

AT-8500 Series Fast Ethernet Switch Installation Guide

Installing an Optional Expansion or Stacking Module

For the

AT-8516F/SC,

AT-8524M, and

AT-8524POE

This section describes how to install an optional expansion or stacking

module in the switch.

Note

The modules can be hot-swapped; you do not have to power off a

switch to install these options.

To install a module, follow these steps:

1. Unpack the module from its shipping container and store the

packaging material in a safe location.

Note

You must use the original shipping material if you need to return

the module to Allied Telesyn.

Warning

An expansion or stacking module can be damaged by static

electricity. Be sure to observe all standard electrostatic discharge

(ESD) precautions, such as wearing an antistatic wrist strap, to avoid

damaging the module.

2. Refer to the module’s installation guide for a list of the items

included with the option. If any item is missing or damaged,

contact your Allied Telesyn sales representative for assistance.

3. Face the front panel of the switch and locate the expansion slots

(left side of switch).

4. To remove an expansion slot faceplate, use a Phillips screwdriver to

carefully loosen the installation screws found on the left and right

sides of the faceplate, as shown in Figure 13.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 113 114

No comments

Allied-telesis AT-8550SP User Manual Page 53