Allied-telesis AT-FS750/24 User Manual download pdf (Page 38)

Chapter 2: Installation

Powering On the Switch

To power on the switch, perform the following procedure:

1. Plug the power cord into the AC power connector on the back of the

switch, as shown in Figure 14.

Figure 14. Plugging in the AC Power Cord

2. Plug the other end of the power cord into a wall outlet.

3. Verify that the POWER LED is green. If the LED is OFF, refer to

Chapter 3, “Troubleshooting” on page 39.

The switch is now powered on and ready for network operations. For

information on how to manage the switch, refer to the AT-S80

Management Software User’s Guide.

Warning: Power cord is used as a disconnection device. To de-

energize equipment, disconnect the power cord.



Pluggable Equipment. The socket outlet shall be installed near

the equipment and shall be easily accessible.



871

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

No comments

Allied-telesis AT-FS750/24 User Manual Page 38