Allied Telesis AR750S-DP Installation Guide download pdf (Page 6)

3-6 AlliedWare OS Software Reference

Software Version 2.8.1

C613-03119-00 REV A

The AR750S and AR750S-DP have default IP configuration for their default

VLAN. To see the default configuration, and a procedure for using the GUI to

connect via the router’s switch ports, see the router’s Installation and Safety

Guide.

Option 1: Configuring the Router before Installation

Use this procedure if:

■ you want to configure the router before installing it in your LAN

■ you want to install the router at a remote office or a customer site and want

to configure it first

■ you want a dedicated management PC permanently connected to the

router

■ you want to use the GUI to connect to the Eth port on an AR750S or

AR750S-DP router. If you want to use the default VLAN, which has an IP

address assigned by default, see the router’s Installation and Safety Guide.

1. Select a PC to browse to the router from.

You can browse to the router from any PC that is running a supported

operating system with a supported browser installed. See “Browser and

PC Setup” on page 3-3 for more information.

You need to know the subnet of the PC.

2. Connect the PC to the router.

Use a straight-through Ethernet cable to connect an Ethernet card on the

PC to any one of the switch ports (see Figure 3-2).

Use a straight-through Ethernet cable to connect an Ethernet card on the

PC to any one of the Ethernet ports (see Figure 3-2).

Figure 3-2: Connecting a PC directly to the router

Important You can browse to the router through any ETH port, or any VLAN

on the AR750S or AR750S-DP, as long as you give that interface an IP address

(below). These instructions assume you are using eth0 as the LAN interface.

3. Access the router’s command line interface.

Access the CLI from the PC, as described in your Installation and Safety

Guide or Quick Install Guide.

4. Enable IP.

enable ip

5. Assign the eth0 interface an IP address in the same subnet as the PC.

add ip interface=eth0 ip=ipaddress mask=mask

DISCONNECT MAINS SUPPLY BEFORE REMOVING

LID. CONTAINS NO USER SERVICEABLE PARTS

POWER

STATUS

BASE BAY 1 BAY 0

ENGINE

ETHERNET PORTS INTERFACE MODULES

PWR RUN SYS FD LNK RXSEC

ACT DAT ERR CLR 10 COL TX

ACT

PRI

E1/T1

SYN

straight-through cable

ETH port

AR700 router

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments

Allied Telesis AR750S-DP Installation Guide Page 6

Comments to this Manuals

Related products and manuals for Network switches Allied Telesis AR750S-DP