Allied Telesis AT-8525 User's Guide download pdf (Page 52)

File Administration Discovery Configurator (Service Provider)

AlliedView NMS Administration Guide

The “Entire Network” radio button, when selected means to use all addresses in the network, specified by the IP Address

and Net Mask fields. When “Set of Nodes” is selected instead, only the addresses from the Start IP to the End IP will be

discovered.

If SNMP discovery is enabled, network discovery will normally use the parameters configured on the SNMP tab, but they can

be overridden for specific networks and subnets by selecting the SNMP option on this tab.The properties to fill in depend on

the SNMP version selected.

A version of SNMP can be chosen to override what is configured for the network. After choosing the SNMP version,

selecting the Properties button allows the parameters to be filled in. Refer to the following figure.

FIGURE 3-7 Setting Properties for SNMPv3

All networks, including the local net, have to be added via the network tab.

Caution: It is not possible to delete a network from discovery once discovery begins on that network. Discovery begins any time

immediately after saving changes. Therefore, to permanently remove a network from the discovery configuration, shut down

the NMS to shut down the discovery process and use the standalone Discovery Configurator to delete the unwanted

network. Networks are successfully deleted, however, when deleted before

saving changes.

The user can add networks and nodes in the Network Inventory screen as Managed Objects and this will take effect

immediately. The menu choice:

• Network Inventory / Edit -> Add Network

• Network Inventory / Edit -> Add Node

brings up the dialog to add a network or node. Refer to 3.3.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 101 102

No comments

Allied Telesis AT-8525 User's Guide Page 52