Patch 54266-03 11
Patch 54266-03
C613-10417-00 Rev C
The PIC bay can accommodate any of the following PICs:
• AT-AR020 PRI E1/T1 PIC, one Primary Rate E1/T1 port.
• AT-AR021(S) BRI-S/T PIC, one Basic Rate ISDN S/T port.
• AT-AR021(U) BRI-U PIC, one Basic Rate ISDN U port.
• AT-AR022 ETH PIC, one Ethernet LAN AUI/10BASE-T port.
• AT-AR023 SYN PIC, one Synchronous port with universal 50-way
AMPLIMITE connector.
• AT-AR024 ASYN4 PIC, four Asynchronous ports with RJ-45
connectors.
• AT-AR026 4ETH PIC, four 10BASE-T/100 BASE-TX auto-negotiating
ports with RJ-45 connectors.
• AT-AR027 VoIP-FXS PIC, two Foreign Exchange Subscriber (FXS) ports
with RJ-11 connectors.
Main system
Main features of the AR440S routers are:
■ 300 MHz RISC processor.
■ 64 MBytes of SDRAM.
■ 16 MBytes of flash memory (1 MByte reserved for boot block code).
■ 5 x 10/100 Mbps full duplex, Layer 2 switched Ethernet LAN ports. All
LAN ports have Auto-MDI, however if Auto-MDI is turned off, then all
ports are hardwired as MDI-X. Software can also force a port to either MDI
or MDI-X. 802.1Q tagged VLANs are supported.
■ 1 x ADSL Annex B port
■ 1 x asynchronous DTE port.
■ Universal AC power supply.
■ On-board hardware encryption processor for DES, 3DES and AES.
Some encryption options may require feature licenses.
The RS-232 asynchronous serial port (ASYN 0) has a DB9 male connector, is
wired as a DTE port and can be used as a general purpose port for terminals,
printers or modems. The default communications settings are:
• 9600 bps
• 8 data bits
•1 stop bit
•no parity
• hardware flow control
ADSL Interfaces
The ADSL port has an RJ11 connector, and supports Dying Gasp.
Comments to this Manuals