Allied Telesis Patch 54266-02 User Manual download pdf (Page 3)

Patch 54266-03 3

Patch 54266-03

C613-10417-00 Rev C

On AR410 and AR450 routers, when VRRP port monitoring was enabled, the

priority of the virtual router did not change even though the states of the ports

on the vlan were changed. This issue has been resolved. (CR5842)

On AR440 router, with a bridge port over virtual ETH, entering the command -

‘SHOW ETH STATE’ caused the router to reboot. This issue has been resolved.

(CR6041)

IGMP Snooping information was not being used when forwarding IGMP

Proxy traffic. The traffic was being forwarded out all ports on a VLAN rather

than just to the registered ports. This issue has been resolved. (CR6376)

If the following set of actions were carried out on the switches:

(1) Create a VRRP instance with port monitoring enabled and a non-

proportional step value

(2) Disable port monitoring on the VRRP instance

(3) Create a configuration script using the command create configuration

then, if the resulting configuration script was used as a boot script, an error

message would be output at the next startup of the switch. This issue has been

resolved. (CR 00007337)

If router received OAM cells there was a posibility that the router may reboot.

This was caused mainly by DSLAM side equipment sending regular OAM

loopback cells to the CPE equipment. This issue has been resolved.

CR00007686

When changing the log output/receive password to a shorter string it could

cause an unnecessary warning. This issue has been resolved. (CR00007716)

PCR: 50009 Module: VRRP Level: 2

PCR: 50014 Module: ETH Level: 2

PCR: 50016 Module: IPG Level: 2

PCR: 50051 Module: VRRP Level: 2

PCR: 50064 Module: ATM Level: 2

PCR: 50070 Module: LOG Level: 2

1 2 3 4 5 6 7 8 ... 15 16

No comments

Allied Telesis Patch 54266-02 User Manual Page 3