Allied Telesis AT-RPS8000 Installation Guide download pdf (Page 34)

Installation

Installing the Switch on a Desktop

The switch can be installed in a standard 19-inch rack or on a table or

desktop. To install the switch in a rack, go to the section Installing the

Switch in a Rack on page 36. To install the switch as a table or desktop,

perform the following steps:

1. Remove all components from the shipping package and store the

packaging material in a safe location.

2. Locate a level, secure surface for the switch.

3. If you purchased an expansion module for the switch, install the

module by following the instructions in the section Installing an

Expansion Module on page 38.

4. If you purchased a redundant power supply (RPS) unit for the switch,

connect the RPS unit to the R.P.S. Input connector (Figure 4) on the

rear of the switch by following the directions included with the RPS

system.

Note

If you intend to use a redundant power supply (RPS) with the

switch, check to be sure that the cable with the RPS unit is

compatible with the RPS Input Port on the switch. The pin

assignments for the connector are provided in Appendix A.

5. Apply AC power to the switch by plugging the power cord into the AC

power connector on the back panel of the unit (shown in Figure 4)

and plugging the other end into a wall outlet.

Figure 4 Switch Rear Panel

Warning

The power cord is used as a disconnection device. To de-energize

equipment, disconnect the power cord. "

AC Power Connector

RPS Connector

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 69 70

No comments

Allied Telesis AT-RPS8000 Installation Guide Page 34