Allied Telesis AT-RPS8000 User Manual download pdf (Page 7)

Quick Install Guide 7

C613-04040-01 REV B

Figure 2: AT-RPS9000 rear panel.

8. Apply power to the AT-PWR9000.

There are two AC inputs on the chassis’s rear panel (see Figure 2 on

page -7). Input A feeds the two bays that supply RPS outputs A1 and A2,

while input B feeds the bays that supply outputs B1 and B2.

Use the provided AC power cord(s) to connect the appropriate bays (bays

that have installed AT-PWR9000 units) to a mains power supply.

9. Activate the RPS output(s).

There are four standby switches on the chassis’s rear panel, one for each

RPS output (see Figure 2 on page -7). Press the standby switch that is

closest to the RPS output you want to activate.

10. Check the RPS and switch LEDs.

RPS and AT-9812T or AT-9816GB switch LEDs indicate the system’s

operational status. See the following section for details.

AT-9800 Series switches have the following power supply related LEDs.

AC INPUT A

AC INPUT

100-240V

50/60

AMPS

5.0-2.5

AC INPUT B

AC INPUT

100-240V

50/60

AMPS

5.0-2.5

RPS OUPUT A1

RPS OUPUT A2

RPS OUPUT B1 RPS OUPUT B2

OUTPUT VDC A Max

0.5

+3.3

+12

OUTPUT VDC A Max

0.5

+3.3

+12

OUTPUT VDC A Max

0.5

+3.3

+12

OUTPUT VDC A Max

0.5

+3.3

+12

AT-RPS9000

AC Input A

(For RPS output A1 & A2)

AC Input B

(For RPS output B1 & B2)

RPS Output A1 RPS Output A2 RPS Output B2RPS Output B1

Power Switches

LEDs and Troubleshooting

AT-PWR9000 units have one LED.

Table 1: AT-PWR9000 LED.

LED State Function

Power Green The PWR is receiving AC power and the voltage

is within an acceptable range

Table 2: Power supply related LEDs found on all AT-9800 Series Switches.

LED State Function

PWR

(Power)

Green The switch is receiving power

1 2 3 4 5 6 7 8 9

Comments to this Manuals

No comments

Allied Telesis AT-RPS8000 User Manual Page 7

Comments to this Manuals

Related products and manuals for Power supply units Allied Telesis AT-RPS8000