Allied-telesis AT-8550SP User Manual download pdf (Page 65)

AT-8500 Series Layer 2+ Fast Ethernet Switches Installation Guide

instructions on how to configure a port trunk, refer to the AT-S62

Management Software User’s Guides.

 When you connect a device to a port on an AT-8524POE switch,

the port automatically determines whether the node is a powered

device and, if it is, the amount of wattage required by the device,

up to a maximum of 15.4 W. If the node is not a powered device,

the port automatically disables the PoE feature.

Warning

To reduce the risk of electric shock, the PoE ports on this product

must not connect to cabling that is routed outside the building where

this device is located.



E40

Cabling Fiber

Optic Ports

If your switch has fiber optic ports, perform the following procedure:

1. Remove the dust covers from the ports, as shown in Figure 20.

Figure 20. Removing the Dust Covers from the Fiber Optic Ports

Note

Do not remove the dust covers if you do not intend to connect the

fiber optic cables at this time. Dust contamination can adversely

impact the operation of the ports.

L/A

TX RX

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 89 90

No comments

Allied-telesis AT-8550SP User Manual Page 65