Allied-telesis AT-8550SP User Manual download pdf (Page 74)

Chapter 2: Installation

 Parity: None

 Stop bits: 1

 Flow control: None

Note

The port settings are for a DEC VT100 or ANSI terminal, or an

equivalent terminal emulator program.

Note

When you reset or power cycle the switch during a local

management session, you will see the following prompt: Press

<CTRL>B to go to Boot Prompt. This message is intended for

manufacturing purposes only. If you inadvertently display the boot

prompt (=>), type boot and press Return to start the switch.

4. Press Return.

You are prompted for a user name and password.

5. To view and configure all of the switch’s operating parameters, enter

the login name “manager”. The default password for manager access

is “friend”. To only view the parameter settings, enter the login name

“operator”. The default password for operator access is “operator”. The

user names and passwords are case-sensitive.

The Main Menu is displayed.

If you logged in with manager access, you can now fully manage the

switch using the management interface. For instructions, refer to the

AT-S62 Management Software User’s Guides. The guides are

available from the Allied Telesis web site at www.alliedtelesis.com and

on the CD included with the switch.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 89 90

No comments

Allied-telesis AT-8550SP User Manual Page 74