Allied Telesis Rapier G6F-SC Installation Guide download pdf (Page 5)

Quick Install Guide 5

C613-04022-01 REV E

Figure 1: Removing a blank face-plate.

6. Prepare the Uplink Module

In an antistatic environment, remove the Uplink Module from its packing

material. Be sure to observe ESD precautions.

Do not attempt to install an Uplink Module or any other expansion option

without observing correct antistatic procedures. Failure to do so may damage

the switch unit or Uplink Module. If you are unsure what the ‘correct’

procedures are, contact your authorised Allied Telesyn distributor or reseller.

7. Slide the Uplink Module into place

Make sure that the module is aligned with the card guides on each side of

the bay (see Figure 2).

Figure 2: Installing an Uplink Module.

8. Secure the Uplink Module to the switch unit

Firmly press the Uplink Module until its connectors engage the uplink bay

connectors inside the switch unit.

Use a screwdriver to tighten the Uplink Module’s screws. Do not

over-tighten the screws.

9. Apply AC power to the switch unit

Plug the power cord into the switch unit’s rear panel. The switch’s Fault

LED should flash for approximately 10 seconds as it runs internal tests.

10. If you disconnected a redundant power supply in step 3, reconnect it

-A

5/S

-F

LINK

ACTIVITY

FULL DUP

HALF DUP

COL

LINK

ACTIVITY

FULL DUP

HALF DUP

COL

Card Guide

1 2 3 4 5 6 7

No comments

Allied Telesis Rapier G6F-SC Installation Guide Page 5