Chapter 18: SNMPv3
262 Section III: SNMPv3
Modifying Target
Address Table
Entry
To modify an entry in the SNMPv3 Target Address Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 44.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 79 on page 224.
3. In the SNMPv3 section, click the button next to Configure Target
Address Table and then click Configure at the bottom of the tab.
The SNMPv3 Target Address Table tab is shown in Figure 95 on page
259.
4. Click Next or Previous to display the Target Address Table entry to be
changed.
5. Click Modify.
The Modify SNMPv3 Target Address page is shown Figure 97.
Figure 97. Modify SNMPv3 Target Address Page
6. In the IP Address field, enter the IP address of the host.
Use the following format for an IP address:
XXX.XXX.XXX.XXX
Comments to this Manuals