Allied-telesis AT-S63 User Manual download pdf (Page 31)

AT-S63 Management Software Web Browser Interface User’s Guide

Section I: Basic Operations 31

software to monitor the traffic on that subnet for the remote management

packets.

If the switch is an isolated unit or the master switch of an enhanced stack,

you must create at least one interface on the device. You create the

interface on the local subnet and VLAN through which your management

workstation is reaching the device. Furthermore, you must designate the

interface as the local interface. To start a remote management session,

you specify the IP address of the local interface as the switch’s IP address.

The slave switches of a stack are handled differently. They do not need

any interfaces nor a local interface to be a part of an enhanced stack.

What is required is that the master and slave switches be interconnected

by a common VLAN and that the VLAN be part of the local interface on the

master switch.

Here is an overview of the required steps to configuring an isolated

AT-9400 Series switch for remote management:

1. Create a routing interface on the local subnet and VLAN from where

your remote management station reaches the switch.

2. Designate the interface as the local interface so the switch monitors

the subnet for the management packets.

3. To start a remote management session using a Telnet client, a web

browser, or an SNMP program, specify the IP address of the switch’s

local interface.

Here is an overview of the steps to configuring an AT-9400 Series master

switch of an enhanced stack for remote management:

1. Create a routing interface on the local subnet and VLAN that

interconnects the switches and from where your remote management

station is reaching the master switch.

2. Designate the interface as the local interface so the master switch

monitors the subnet for the management packets.

3. To start a remote management session on the enhanced stack using a

Telnet client, a web browser, or an SNMP program, specify the IP

address of the local interface on the master switch.

Here is an overview of the steps for a slave switch of an enhanced stack:

1. Connect the slave switch to the master switch using a common VLAN

and subnet. (A slave switch does not need a routing interface on the

common VLAN to support remote management of the device when

part of an enhanced stack.)

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 429 430

No comments

Allied-telesis AT-S63 User Manual Page 31