Allied Telesis AT-RPS8000 Specifications download pdf (Page 14)

14 AT-8800 Series Switch

C613-03066-00 REV D

See “Using Windows Terminal and Windows Hyperterminal” on page 10

for more information on configuring emulation software.

Ensure that any power switches are in the On position and that the switch

is receiving power.

After the switch has booted, the log in prompt appears. If the log in prompt

doesn’t appear, press [Enter] two or three times.

When the switch boots for the first time it automatically creates an account

with manager privileges. The account has the log in name “manager” and

the password is “friend”.

At the log in prompt, enter the log in name and password.

Password: friend

The switch’s command prompt appears and you can now configure the

switch using the command line interface.

Change the password as soon as possible. Leaving the manager account with

the default password is a serious security risk. Make sure that you remember

the new password as there is no way to retrieve it if it is lost.

Use the following command to change the account password:

set password

See the AT-8800 Series Software Reference for more information on

configuring the switch.

To access help

To display a list of help topics, enter:

help

To display help on a specific topic, enter:

help

topic

Alternatively, type a question mark (?) at the end of a partially completed

command to see a list of valid options.

Start-up Procedures

When the switch starts up following either a power cycle or an operator-

initiated reboot (using the Reset button or RESTART command), a series of

start-up messages is sent to the terminal or PC connected to ASYN0 (Figure 4

on page 15).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

No comments

Allied Telesis AT-RPS8000 Specifications Page 14