Allied Telesis AT-RPS8000 Specifications download pdf (Page 29)

Hardware Reference 29

C613-03066-00 REV D

Perform the following steps in sequence:

1. Check “LEDs and What They Mean” on page 26 for descriptions and

explanations of LED flashing sequences.

2. Reset the switch by pressing the recessed RESET button on the front panel.

3. If you were attempting to download software or manage the switch via the

RS-232 Terminal Port, check that connections between the Terminal Port

and local terminal or PC are secure.

If you cannot access the switch’s software because of a faulty RS-232

Terminal Port connection, you can still manage the switch via Telnet or

SNMP until the problem is fixed.

4. Download the latest software release. See the AT-8800 Series Software

Reference for more information on how to obtain the latest software release.

Expansion Options

This section provides an overview of the expansion options for AT8800 Series

Switches. The following expansion options were available when this Reference

was written. See your Authorised Allied Telesyn distributer or reseller, or visit

www.alliedtelesyn.co.nz/support/at8800/ to see if any new options are

available.

Gigabit Interface Converters (GBICs)

GBICs are removable gigabit port converters for switches that have GBIC bays.

GBICs allow users to interchange port types to meet changing network

requirements. GBICs can be purchased when a switch is purchased, or can be

ordered separately as needed.

The following GBICs have been approved for use with AT-8800 Series switches:

■ Allied Telesyn AT-G9T

■ Allied Telesyn AT-G8T

■ Allied Telesyn AT-G8ZX 70km ZX

■ Allied Telesyn AT-G8SX 550m SX

■ Allied Telesyn AT-G8LX10 10km LX

■ Allied Telesyn AT-G8LX25 25km LX

■ Allied Telesyn AT-G8LX40 40km LX

■ Allied Telesyn AT-G8LX70 70km LX

For more information about GBICs and the latest list of approved GBICs,

contact your authorised Allied Telesyn distributor or reseller visit

www.alliedtelesyn.co.nz/support/at8800/.

Any combination of copper and fibre GBICs can be installed in the AT-8800

Series switches.

RX and TX terminal locations on SC fibre GBIC ports are the reverse of RX and TX

terminal locations on fixed SC fibre ports. When looking at an SC fibre GBIC from the

front, the RX terminal is on the left and the TX terminal is on the right.

1 2 ... 24 25 26 27 28 29 30

No comments

Allied Telesis AT-RPS8000 Specifications Page 29