Allied Telesis AT-FS201 Installation Guide Page 35

  • Download
  • Add to my manuals
  • Print
  • Page
    / 88
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 34
AT-FS20x Series Installation Guide
25
When setting the DIP switches, consider the following:
Setting the Auto Neg DIP switch for the twisted pair port to ON or OFF
enables or disables Auto-Negotiation for the port. If you disable Auto-
Negotiation, be sure to set the DIP switches for the port’s speed and
duplex mode to match the speed and duplex mode of the end-node.
Disabling Auto-Negotiation on the twisted pair port also disables Auto
MDI/MDI-X and configures the port as MDI-X.
For the fiber optic port, set the port’s duplex mode using the
appropriate Duplex Mode DIP switch. This setting must match the
duplex mode capability of the end-node to be connected to the port.
5. If you are installing the converter in an AT-MCR12 chassis, refer to
the AT-MCR12 Chassis Installation Guide from our web site for
instructions on how to install the converter in the chassis, then
proceed to Step 8.
6. Place the converter on a secure, level surface, leaving ample space
around the converter for ventilation.
7. Apply power to the converter.
21Duplex
Mode
Up
Down
The fiber optic port operates in
half-duplex mode.
The fiber optic port operates in
full-duplex mode.
32Duplex
Mode
Up
Down
The twisted pair port operates
in half-duplex mode.
The twisted pair port operates
in full-duplex mode.
4 2 Auto Neg Up
Down
Auto-Negotiation on the twisted
pair port is OFF.
Auto-Negotiation on the twisted
pair port is ON.
Table 5. DIP Switch Settings (Continued)
DIP
Switch
No.
Port Setting Position Description
Page view 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 87 88

Comments to this Manuals

No comments