Allied Telesis AT-FS201 Installation Guide download pdf (Page 60)

Appendix C: Translated Electrical, Safety, and Emission Information

21 Warning: The power source for the gateway unit should be

located near the unit and should be easily accessible.

22 Caution: To allow proper cooling of the gateway device, make

sure that the air flow around the unit and through its heatsink

cooling fins on the rear is not restricted.

23 Circuit Overloading: Consideration should be given to the

connection of the equipment to the supply circuit and the effect

that overloading of circuits might have on overcurrent protection

and supply wiring. Appropriate consideration of equipment

nameplate ratings should be used when addressing this

concern.

24 Caution: Risk of explosion if battery is replaced by an incorrect

type. Replace only with the same or equivalent type

recommended by the manufacturer. Dispose of used batteries

according to the manufacturer’s instructions.

Attention: Le remplacement de la batterie par une batterie de

type incorrect peut provoquer un danger d’explosion. La

remplacer uniquement par une batterie du mкme type ou de

type йquivalent recommandйe par le constructeur. Les batteries

doivent кtre йliminйes conformйment aux instructions du

constructeur.

25 Warning: For centralized DC power connection, install only in a

restricted access area.

26 A tray cable is required to connect the power source if the unit is

listed Type TC tray cable and rated at 600 V and 90 degrees C,

with three conductors, minimum 14 AWG.

27 Warning: Mounting of the equipment in the rack should be such

that a hazardous condition is not created due to uneven

mechanical loading.

28 Warning: Remove all metal jewelry, such as rings and watches,

before installing or removing a line card from a powered-on

chassis.

29 Use dedicated power circuits or power conditioners to supply

reliable electrical power to the device.

30 Warning: The chassis may be heavy and awkward to lift. Allied

Telesyn recommends that you get assistance when mounting

the chassis in an equipment rack.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 87 88

No comments

Allied Telesis AT-FS201 Installation Guide Page 60