AT-GS950/10PS, AT-GS950/16PS, and AT-GS950/48PS Switches Installation Guide
39
Installing the Switch on a Wall
Only the AT-GS950/10PS and AT-GS950/16PS switches can be installed
on a wall.
The AT-GS950/48PS is too heavy to be safely installed on a wall.
To AT-GS950/10PS or AT-GS950/16PSinstall the switch on a wall,
perform the following procedure:
1. Turn the switch over and place it on a table.
2. If the rubber feet are attached to the bottom of the switch, remove
them using a flat-head screwdriver.
3. Orient the brackets against the sides of the switch as shown in Figure
23, and secure them to the unit with the eight brackets screws included
with the switch.
Figure 23. Attaching the Brackets to Install the Switch on a Wall
Comments to this Manuals