Chapter 3: Installation
26
Mounting the AT-CV1000 Chassis on a Wall
The AT-CV1000 chassis is shipped with two wall-mounting brackets. The
chassis is designed to be mounted vertically on a wall using the keyholes
on the wall-mounted brackets.
To mount the AT-CV1000 chassis on a wall, perform the following
procedure:
1. If attached, remove the rubber feet, data cables, and power cord from
the chassis.
2. Install the line card according to the instructions in “Installing a
Converteon™ Line Card” on page 32.
3. Install the provided wall-mount brackets onto the chassis, as illustrated
in Figure 8.
Figure 8. Installing the Wall-Mount Brackets on the Chassis
4. Select a wall location for the device.
5. Place the chassis against the wall and mark the locations for the wall
anchors.
AT-CM202
LK A
T
S
F
P
LK AT FD
AT-CV1000
SML ML OAM
T
X
R
D
Y
263
C
L
A
S
S
1
L
A
S
E
R
P
R
O
D
U
C
T
Caution: The attached mounting brackets must be used to
securely mount the device on the wall.
E15
Comments to this Manuals