AT-FS750/24-41 Web User Interface Manual
6-23
Select a line to change the configuration.
To enable or disable IGMP Snooping globally. Default is enabled.
Specify the operational status of IGMP snooping function.
Speficy the Snooping mode of IGMP snooping function.
Specify which port to forward the IGMP report. Select All Ports to forward the
report to all ports, Router Ports to forward the reports to IGMP router ports
only. Default is Router Ports.
To set the maximum retries for group specific queries which sent to a port
received a IGMPv2 leave message. The possible number is 1-5 times. Default
is 2.
Specify if the IGMP queries will still be sent when STP topology change
happens. Select Enable to transmit the queriers, Disabled not to transmit.
Default is Disabled.
Click Apply to submit the changes.
IGMP Snooping Timer Configuration
This page is to configure the IGMP Snooing timers.
Figure 60 – Layer2 Management > IGMP Snooping > Timer Configuration
Router Port Purge
Interval (60~600 Secs)
To set the time-out period that an IGMP multicast router port hasn‟t received
IGMP router control packet, it will be deleted. Default is 125 seconds.
Group-Member Port
Purge Interval
(130~2335 Secs)
To set the purge interval that an IGMP member port hasn‟t‟ received IGMP
report packet, it will be deleted. Default is 260 seconds.
Report Forward
Interval (1~25 Secs)
To set the time interval that IGMPv2 report of the same group will not be
forwarded to the router ports. Default is 5 seconds.
Group Query Interval
(1~5 Secs)
To set up the time interval to send the group specific query. Default is 2
seconds.
Querier Query Intercal
(60~600 Secs)
To set up the time interval to send the IGMP general query. Default is 125
seconds.
Click Apply to submit the changes, Reset to clear the values just inputed.
IGMP Snooping Interface Configuration
This page is to cunfigure the VLAN bassis IGMP snooping settings.
Comments to this Manuals