Allied-telesis AT 8000/8POE User Manual download pdf (Page 185)

AT-S81 Management Software User’s Guide

Section I: Using the Menus Interface 185

F (Force-authorized) - Disables IEEE 802.1x authentication

and causes the port to transition to the authorized state without

any authentication exchange required. The port transmits and

receives normal traffic without 802.1x-based authentication of

the client. This is the default setting.

b. Type A, U, or F.

8. To configure the transmission period, do the following:

a. Type T to select Transmission Period.

The following prompt is displayed:

Enter transmission period >

This parameter sets the number of seconds that the switch waits

for a response to an EAP-request/identity frame from the client

before retransmitting the request. The default value is 30 seconds.

The range is 1 to 65,535 seconds.

b. Type a number for the transmission period.

9. To set the supplicant timeout, do the following:

a. Type L to select Supplicant Timeout.

The following prompt is displayed:

Enter supplicant timeout value >

This parameter sets the switch-to-client retransmission time for the

EAP-request frame. The default value for this parameter is 30

seconds. The range is 1 to 600 seconds.

b. Type a number for the supplicant timeout.

10. To set the server timeout, do the following:

a. Type O to select Server Timeout.

The following prompt is displayed:

Enter transmission period >

This parameter sets the timer used by the switch to determine

authentication server timeout conditions. The default value for this

parameter is 10 seconds. The range is 1 to 60 seconds.

b. Type a number for the server timeout.

11. To set the maximum number of requests, do the following:

a. Type M to select Maximum Request.

1 2 ... 180 181 182 183 184 185 186 187 188 189 190 ... 359 360

No comments

Allied-telesis AT 8000/8POE User Manual Page 185