Allied-telesis AT 8000/8POE User Manual download pdf (Page 59)

AT-S81 Management Software User’s Guide

Section I: Using the Menus Interface 59

Returning the AT-S81 Management Software to the Factory Default

Values

This procedure returns all AT-S81 management software parameters to

their default values and deletes all tagged and VLANs on the switch. The

AT-S81 management software default values are listed in Appendix A,

”AT-8000/POE Default Settings” on page 345.

Caution

This procedure causes the switch to reboot. The switch does not

forward network traffic during the reboot process. Some network

traffic may be lost.

To return the AT-S81 management software to the default settings,

perform the following procedure:

1. From the Main Menu, type T to select Switch Tools.

The Switch Tools Configuration Menu is shown in Figure 11 on page

50.

2. From the Switch Tools Menu, type R to select System Reboot to start

the reboot.

The System Reboot menu is shown in Figure 12 on page 51.

3. Type O to select Set Reboot Option.

The following prompt is displayed:

Select reboot option (F/I/N)>

4. Type F or I to select one of the following:

F (Factory Default)

Resets all switch parameters to the factory default settings, including

IP address, subnet mask, and gateway address.

I (Reset to Defaults Except IP Address)

Resets all switch parameters to the factory default settings, but retains

the IP address, subnet mask, and gateway settings. If the DHCP client

is enabled, it remains enabled after this reset.

Note

Option N is described in “Rebooting the Switch” on page 50.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 359 360

No comments

Allied-telesis AT 8000/8POE User Manual Page 59