Allied-telesis AT 8000/8POE User Manual download pdf (Page 77)

AT-S81 Management Software User’s Guide

Section I: Using the Menus Interface 77

Working with Trap Receivers

This section contains procedures for working with SNMP trap receivers

and includes the following topics:

 “Adding a Trap Receiver,” next

 “Enabling or Disabling Trap Receivers” on page 77

 “Modifying a Trap Receiver” on page 78

 “Deleting a Trap Receiver” on page 79

Adding a Trap

Receiver

You must add a trap receiver before you can enable it.

To add a trap receiver, perform the following procedure.

1. From the Main Menu, type B to select Basic Switch Configuration.

The Basic Switch Configuration Menu is shown in Figure 4 on page 32.

2. From the Basic Switch Configuration menu, type N to select SNMP

Configuration.

The SNMP Configuration menu is shown in Figure 19 on page 75.

3. Type A to select Add SNMP Trap Receiver.

The following prompt is displayed:

Add SNMP trap receivers->Enter entry number>

4. Enter 1 through 4 for the trap receiver you want to configure.

The following prompt is displayed:

Enter IP address for trap receiver>

5. Enter the IP address of the workstation that you want to receive traps.

The following prompt is displayed:

Enter community name for trap receiver>

6. Enter a name for the workstation that you want to receive traps.

A new trap receiver is automatically enabled.

Enabling or

Disabling Trap

Receivers

You can disable a trap receiver or enable one that was previously

disabled. To enable or disable a trap receiver, perform the following

procedure:

1. From the Main Menu, type B to select Basic Switch Configuration.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 359 360

No comments

Allied-telesis AT 8000/8POE User Manual Page 77