Allied-telesis AT 8000/8POE User Manual download pdf (Page 244)

Chapter 19: Basic Switch Parameters

244 Section II: Web Browser Interface

Returning the AT-S81 Management Software to the Factory Default

Values

This procedure returns all AT-S81 management software parameters to

their default values and deletes all tagged and VLANs on the switch. The

AT-S81 management software default values are listed in Appendix A,

“AT-8000/POE Default Settings” on page 345.

Caution

This procedure causes the switch to reboot. The switch does not

forward network traffic during the reboot process. Some network

traffic may be lost.

To return the AT-S81 management software to the default settings,

perform the following procedure:

1. From the Tools menu, select System Reboot.

The System Reboot Configuration page is shown in Figure 68 on page

238.

2. For the Reboot Type, select one of the following:

Reset to Factory Default

Resets all switch parameters to the factory default settings, including

IP address, subnet mask, and gateway address.

Reset to Factory Default Except IP Address

Resets all switch parameters to the factory default settings, but retains

the IP address, subnet mask, and gateway settings. If the DHCP client

is enabled, it remains enabled after this reset.

3. For the Reboot Status, select Start to start the reboot.

4. Click Apply.

The switch is rebooted. You must wait for the switch to complete the

reboot process before reestablishing your management session.

1 2 ... 239 240 241 242 243 244 245 246 247 248 249 ... 359 360

No comments

Allied-telesis AT 8000/8POE User Manual Page 244