Allied Telesis AT-FS201 Installation Guide download pdf (Page 23)

AT-FS20x Series Installation Guide

DIP Switches

The DIP switches are used to manually configure the operating

characteristics of the ports, such as port speed, duplex mode, and Auto-

Negotiation.

For the 100Base-FX fiber optic port, you can manually set the duplex

mode to either half- or full-duplex.

On the 10Base-T/100Base-TX twisted pair port, you can manually set the

speed of the port to either 10 Mbps or 100 Mbps, set the duplex mode to

either half- or full-duplex, and enable or disable Auto-Negotiation.

Enabling Auto-Negotiation will automatically set the port’s speed and

duplex mode.

Note

A change to the DIP switch setting does not take effect until after

you reset the unit. To reset the unit, power the unit OFF then ON.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 87 88

No comments

Allied Telesis AT-FS201 Installation Guide Page 23