Allied Telesis AT-x230-10GP Installation Guide download pdf (Page 17)

AT-x230-10GP and AT-x230-18GP Switches Installation Guide

LEDs Here is a brief description of the port LEDs:

 POWER and FAULT LEDs; refer to “POWER and FAULT LEDs”

on page 22.

 Link/Activity/Speed/PoE LEDs for the twisted pair ports; see “10/

1000BASE-T/100BASE-TX Link/Activity/Speed LED and PoE

status LED” on page 24.

 Link/Activity LEDs for the SFP slots; see “SFP LEDs” on page 27.

 SD card LED: refer to “SD card LED” on page 28.

Note

The ecofriendly button turns off the LEDs (excluding the POWER

LED) to conserve electricity. See “ecofriendly button” on page 30.

Installation

options

The AT-x230-10GP and AT-x230-18GP switches can be installed in the

following ways:

 Rack mounted in a 19-inch equipment rack

 Mounted on a desk or tabletop

 Wall mounted

Power

conservation

The AT-x230-10GP and AT-x230-18GP switches implement Eco-Switch

Green Power saving features and use less power than the METI

specification. The switches have the following power conservation

features:

 ecofriendly button to turn off the port LEDs when the system is not

being monitored

 High efficiency power supply

 Power scaling based on traffic loads on ports operating at

1000Mbps (port power scaling not available at 10 or 100Mbps)

 Power shutdown on unused ports

MAC address

table

Here are the basic features of the MAC address table:

 Storage capacity up to 16KB MAC address entries

 Automatic learning and aging

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 79 80

No comments

Allied Telesis AT-x230-10GP Installation Guide Page 17