Allied Telesis AT-x230-10GP Installation Guide download pdf (Page 64)

Chapter 2: Installation

Starting a local management session

This procedure requires a terminal or a terminal emulator program and the

management cable that comes with the switch. To start a local

management session on the switch, perform the following procedure:

1. Connect the RJ45 connector on the management cable to the console

port on the front panel of the switch, as shown below.

FIGURE 25. CONNECTING THE MANAGEMENT CABLE TO THE CONSOLE PORT

OF AN X230 SERIES SWITCH

x230-10GP

CONSOLE

RS-232

FAULT

POWER

1000 LINK

ACT

10/100 LINK

ACT

2 4

MAC Address Label

2. Connect the other end of the cable to an RS-232 port on a terminal or

PC with a terminal emulator program.

3. Configure the terminal or terminal emulator program as follows:

 Baud rate: 9600 bps (The baud rate of the Console Port is

adjustable from 1200 to 115200 bps. The default is 9600 bps.)

 Data bits: 8

 Parity: None

 Stop bits: 1

 Flow control: None

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 79 80

No comments

Allied Telesis AT-x230-10GP Installation Guide Page 64