Allied Telesis AT-x230-10GP Installation Guide download pdf (Page 45)

AT-x230-10GP and AT-x230-18GP Switches Installation Guide

All countries: Install product in accordance with local and National

Electrical Codes.  E8

Circuit overloading: Consideration should be given to the

connection of the equipment to the supply circuit and the effect that

overloading of circuits might have on overcurrent protection and

supply wiring. Appropriate consideration of equipment nameplate

ratings should be used when addressing this concern.  E21

Warning

Mounting of the equipment in the rack should be such that a

hazardous condition is not created due to uneven mechanical

loading.  E25

If installed in a closed or multi-unit rack assembly, the operating

ambient temperature of the rack environment may be greater than

the room ambient temperature. Therefore, consideration should be

given to installing the equipment in an environment compatible with

the manufacturer’s maximum rated ambient temperature (Tmra). 

E35

Caution

Installation of the equipment in a rack should be such that the

amount of air flow required for safe operation of the equipment is not

compromised.  E36

Warning

Reliable earthing of rack-mounted equipment should be maintained.

Particular attention should be given to supply connections other than

direct connections to the branch circuits (e.g., use of power strips).

 E37

Warning

To reduce the risk of electric shock, the PoE ports on this product

must not connect to cabling that is routed outside the building in

which the device is located.  E40

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 79 80

No comments

Allied Telesis AT-x230-10GP Installation Guide Page 45