Allied Telesis AT-x230-10GP Installation Guide download pdf (Page 58)

Chapter 2: Installation

Installing the switch on a wall using brackets

These instructions show you how to install an AT-x230-10GP or AT-x230-

18GP switch on a wall. Wall mount kits can be purchased separately from

your Allied Telesis dealer.

Note

In the following illustrations, only the AT-x230-10GP switch is

shown.

To install the switch on a wall, perform the following procedure:

1. Turn the switch over and place it on a table.

2. If the rubber feet are attached to the bottom of the switch, remove

them with a screwdriver (Figure 18), then turn the switch back over.

3. Orient the brackets against the sides of the switch as shown in Figure

21, and secure them to the unit with the 16 brackets screws included in

the wall mount kit.

IGURE 21. ATTACHING THE WALL MOUNT BRACKETS TO THE SIDE OF THE

SWITCH

x230-10GP

CONSOLE

RS-232

FAULT

POWER

1000 LINK

ACT

10/100 LINK

ACT

PD ON PD ERR MAX CURRENT

1357

MAC Address Label

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 79 80

No comments

Allied Telesis AT-x230-10GP Installation Guide Page 58