Allied Telesis AT-x230-10GP Installation Guide download pdf (Page 32)

Chapter 1: Overview

LEDs

This section describes the four types of LEDs on the x230 Series

Switches:

 “POWER and FAULT LEDs” on page 22

 “10/1000BASE-T/100BASE-TX Link/Activity/Speed LED and PoE

status LED” on page 24

 “SFP LEDs” on page 27

 “SD card LED” on page 28

POWER and

FAULT LEDs

The POWER LED reports the status of AC power and is located on the

front panel of the of the switches beside the console port. See Figure 7.

Note

All port LEDs are OFF when the switch is operating in the low power

mode. To toggle on the LEDs, use the ecofriendly button. See

“ecofriendly button” on page 30 for more information.

FIGURE 7. POWER LED ON AN X230 SERIES SWITCH

POWER LED

10GP

CONSOLE

RS-232

FAULT

POWER

1000 LINK ACT 10/100 LINK ACT

ess Label

Power LED

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 79 80

No comments

Allied Telesis AT-x230-10GP Installation Guide Page 32