Allied Telesis AT-8000GS User's Guide download pdf (Page 108)

Configuring Spanning Tree

Configuring Classic Spanning Tree

Page 108

Section 9. Configuring Spanning Tree

Spanning Tree Protocol (STP) provides tree topography for any arrangement of bridges. STP also provides a

single path between end stations on a network, eliminating loops.

Loops occur when alternate routes exist between hosts. Loops in an extended network can cause bridges to

forward traffic indefinitely, resulting in increased traffic and reducing network efficiency.

The device supports the following STP versions:

• Classic STP — Provides a single path between end stations, avoiding and eliminating loops. For more

information on configuring Classic STP, see Configuring Classic Spanning Tree.

• Rapid STP — Detects and uses network topologies that provide faster convergence of the spanning tree,

without creating forwarding loops. For more information on configuring Rapid STP, see Configuring Rapid

Spanning Tree.

• Multiple STP — Provides various load balancing scenarios. For example, if port A is blocked in one STP

instance, the same port can be placed in the Forwarding State in another STP instance. For more information

on configuring Multiple STP, see Configuring Multiple Spanning Tree.

This section contains the following topics:

• Configuring Classic Spanning Tree

• Configuring Rapid Spanning Tree

• Configuring Multiple Spanning Tree

Configuring Classic Spanning Tree

This section contains the following topics:

• Defining STP Properties

• Defining STP Interfaces

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 204 205

No comments

Allied Telesis AT-8000GS User's Guide Page 108