Allied Telesis AT-8000GS User's Guide download pdf (Page 166)

System Utilities

Page 166

If the TFTP Operation is Configuration, the possible values are:

– Running Configuration — Contains the configuration currently valid on the device.

– Starting Configuration — Contains the configuration which will be valid following system startup or

reboot.

Note

The configuration file is copied only to the Master Unit, since this unit controls the entire stack. The

configuration file is automatically synchronized with the configuration file on the Backup Unit, so that in the

event of failure of the Master Unit, the Backup Unit takes over immediately with the same configuration

information.

• TFTP Server IP Address — Specifies the TFTP Server IP Address from which files are downloaded.

To download or upload TFTP Files:

1. Select the TFTP Operation type: upload or download; firmware or configuration file.

2. Define the Source file and Destination file type.

3. Click Apply.

In the Copy Files section, network administrators can copy firmware or configuration files from one device to

another.

• Copy Master Firmware —Copies the Firmware or the Boot file from the Stacking Master.

– Software Image — Downloads the Image file.

• Destination Unit — Downloads firmware or the Boot file to the designated unit. The values are:

– All — Copies the Firmware or the Boot file to all stacking members.

To copy firmware:

1. Click Copy Master Firmware. The copy firmware parameters are activated.

2. Select the Source and the Destination Unit.

3. Click Apply.

The Configuration Copy section of the File System Page contains the following fields:

• Copy Configuration— Allows the copy configuration operation.

• Source File Name — Specifies the configuration file type to be copied.

– Startup Configuration — Copies the Startup Configuration file, and overwrites the old Startup

Configuration file.

– Running Configuration — Copies the Running Configuration file.

• Destination File Name — Specifies the destination file type to create. The possible field values are:

– Startup Configuration — Downloads the Startup Configuration file, and overwrites it.

– Running Configuration — Downloads commands into the Running Configuration file.

To copy configuration:

1. Click Copy Configuration. The copy configuration parameters are activated.

2. Select the Source file name and the Destination file name.

3. Click Apply.

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 204 205

No comments

Allied Telesis AT-8000GS User's Guide Page 166