Configuring Services
Page 161
The Configure DSCP Page contains the following fields:
• Restore Defaults — Restores the device factory defaults for mapping DSCP values to a forwarding queue.
• DSCP In — Displays the incoming packet’s DSCP value.
• Queue — Defines the traffic forwarding queue to which the DSCP priority is mapped. Four traffic priority
queues are supported.
4. Modify the Queue values.
5. Click Apply. The DSCP to Queue mapping is updated.
6. Click Save Config on the menu to save the changes permanently.
Configuring QoS Bandwidth
The Bandwidth Page allows network managers to define the bandwidth settings for a specified egress interface.
The Bandwidth Page is not used with the Service mode, as bandwidth settings are based on services.
To configure bandwidth:
1. Click Services > Bandwidth. The Bandwidth Page opens:
Figure 122:Bandwidth Page
Comments to this Manuals