Allied Telesis AT-x230-10GP Installation Guide download pdf (Page 52)

Chapter 2: Installation

Installing an AT-x230-10GP switch in an equipment rack

These instructions show you how to install an AT-x230-10GP switch in an

equipment rack. Rack mount kits for the AT-x230-10GP switch, AT-

RKMT-J14, can be purchased separately from your Allied Telesis dealer.

To install an AT-x230-10GP switch in a 19-inch equipment rack, follow

these steps:

1. If rubber feet are attached to the base of the switch, place the unit

upside down on a level, secure surface.

2. Remove the rubber feet with a screwdriver (Figure 15).

FIGURE 15. REMOVING THE RUBBER FEET FROM A SWITCH

x230-10GP

CONSOLE

RS-232

FAULT

POWER

1000 LINK ACT 10/100 LINK ACT PD ON PD ERR MAX CURRENT

SFP

24 68

1357

MAC Address Label

3. Turn the switch back over.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 79 80

No comments

Allied Telesis AT-x230-10GP Installation Guide Page 52